Back; Input Channels; Aux Channels; Recording Output - AKG DMM 4/2/4 Stereo User Instructions

Back

DMM 4/2/4 Stereo
Figure 2: Back of DMM 4/2/4
1, 3, 4, 6:

Input channels

2, 5: DIP switch
7,8:

AUX channels

9:

Recording output

10a: Stereo output channel, left
10b: Stereo output channel, right
11a: External control connection
11b: PC connection
12: Expansion connectors
13: Ground lift switch
14: Mains switch
15: Mains connection
Input channels
The four balanced input channels can be accessed via 3-pin XLR sockets. These are labelled
"IN 1 - MIC/LINE" to "IN 4 - MIC/LINE". The input levels can be adjusted using the rotary
controls "IN 1 - MIC/LINE" to "IN 4 - MIC/LINE" on the front panel.
Between two XLR sockets there are 6-way DIP switches. This can be used to configure two
input channels in each case.
OFF
1 2 3 4 5 6
IN 1 - MIC/LINE IN 1 IN 2
Figure 3: DIP switches for the input channels
"Phantom Pwr" - switch phantom power on/off on both audio wires of the selected channel.
"Line/Mic" - switch preamp from microphone to line input. In that case the gain is 0 dB.
"Mic-Hi/Lo" - switch gain from +60 dB to +40 dB.
AUX channels
The two auxiliary input channels can be accessed via two RCA jacks. The RCA jacks are
labelled "IN 5 - AUX" and "IN 6 - AUX". The input levels can be adjusted with the rotary
controls "IN 5 - AUX" and "IN 6 - AUX" on the front panel.
Recording output
Two RCA jacks, labelled "OUT REC", are available for connecting recording equipment. A
mono signal is present at each of the two jacks.
OFF
1 2 3 4 5
IN 2 - MIC/LINE IN 3 - MIC/LINE IN 3 IN 4
Description
6
IN 4 - MIC/LINE
33