Do you have a question about the SPOA and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Hiland SPOA
Page 1
Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-888-775-1330, 8 a.m. - 4 p.m., PST, Monday - Friday.
TABLE OF CONTENTS Safety Information ....................3 Expanded Diagram................5 Parts List ......................6 Assembly Instructions..................7 Gas Cylinder Use.................... 14 Operating Instructions..................15 Care and Maintenance....................17 Warranty ........................19...
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. 1. The installation of this appliance must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Code, CSA/CGA-B149.1.
Page 4
the gas supply system at test pressures equal to or less than 1/2 psi (3.5 kPa). 20. CALIFORNIA PROPOSITION 65 WARNING: The burning of gas cooking fuel generates some by products that are on the list of substances known by the State of California to cause cancer, reproductive harm, or other birth defects.
Parts List PART NAME CHIMNEY OVEN DOOR HINGE HEAT SPACER BACK HEAT-SHIELD BACK PANEL EXTERIOR INTERIOR ASSEMBLY LATCH GAS PIPE JOINT GAS PIPE WHEEL CART SUPPORT WHEEL AXLE CHECK NUT CART BOTTOM PLATE CART FRONT PLATE LEG R RUBBER FOOT LEG L GREASE TRAY HOLDER GREASE TRAY...
ASSEMBLY INSTRUCTIONS Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Assembly tip! (Please lightly tighten the screws during assembly of the cart. When the cart is completed THEN TIGHTEN ALL THE screws.
Page 8
STEP 2 Use 2pcs check nut to assemble the wheel and wheel axle as shown.
Page 9
STEP 3 Use 6 M6*10 screws and 6 M6 nuts to assemble the Cart Front Panel to the Cart Legs. STEP 4 Use 4 M6*10 screws and 4 M6 nuts to assemble the handle as shown.
STEP 5 Use 4 M6*10 screws and 4 M6 nuts to assemble the body and the cart as shown, use bolt to tighten. STEP 6 Use 3 M4*12 screws to assemble the chimney as shown.
STEP 7 Use 4 M5*30 screws and heat insulation washer to attach the back heat shield onto the back panel of the oven as shown. STEP 8 Place the bottom rack, pizza stone and cooking grill (2pcs) into the oven as shown.
Page 12
OPTIONAL ACCESSORIES Put the flame temper and smoker box assembly (hang on the cooking grill, exact position is according to the food position) into the oven as shown. STEP 9 Insert the knob as shown.
GAS CYLINDER USE GAS CONNECTIONS In the case of a problem arising with the hose and regulator please contact your gas oven supplier for a list of approved replacement parts . The hose and regulator assembly parts must be an indication gas association approved part. LEAK TESTING This should be done the first time you connect up the pizza oven, and again every time you disconnect and reconnect any fitting.
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS. IF A LEAK PERSISTS, CALL AN AUTHORISED PERSON. WARNING STORE CYLINDER IN A WELL VENTILATED AREA OUT OF REACH OF CHILDREN OPERATING INSTRUCTIONS LIGHTING PROCEDURE 1. Lighting the gas oven is easy, but must be done with care. 2.
Page 16
CONTROLLING THE FLAMES The knobs have three basic positions. You can achieve any flame height between low and high by rotating the knob between positions. Note: “Blowback” is a situation where the flame burns inside the burner , towards the front, recognised by a sharp roaring sound coming from the burner. It is not dangerous unless allowed to persist.
Out of Adjustment: Hard blue flames-too much air Care & Maintenance GENERAL MAINTENANCE - Keep outdoor cooking gas appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. - Do not obstruct the flow of combustion and ventilation air. - Keep the ventilation openings of the cylinder enclosure free and clear from debris.
Page 18
Replacing Battery for Electrical Igniter: 1. Remove the igniter cap by turning counterclockwise; 2. Replace the battery; 3. When installing new battery, ensure it is installed with the positive side facing outward; 4. Put on the igniter cap back by turning clockwise.
Using Your Pizza Oven USAGE TIPS Preheating Smoking with the Pizza Oven It is necessary to preheat the appliance for at least Your Pizza Oven can be used as a hot smoker. Hot 15 minutes before cooking certain foods, smoking will not produce the intense smoked depending on the type of food and the cooking flavors obtained by cold smoking for long periods temperature.
ONE-YEAR LIMITED WARRANTY Do not return this product to the store where you purchased it. Please call 1-888-775-1330 for assistance. This product is inspected, tested and carefully packaged to minimize the chance of damage during shipment. If a part (excluding light bulbs and fuses*) within one year from the date of purchase proves to be defective in material or fabrication under normal use, the part will be repaired or replaced.
Need help?
Do you have a question about the SPOA and is the answer not in the manual?
Questions and answers