User Interface - Curtis DVBTUK-T3 User Manual

User Interface

The 'Exit ' key will close on screen menus .
All menus will automatically be removed after 30 seconds unless
otherwise stated.
1)Welcome Screen
When the STB is powered up for the first time or is brought out of
standby a welcome screen will be displayed. This will tell the user
to press the OK key to start a full frequency service scan.
2) Volume Control
A bar will be displayed when volume is changed by pressing Vol+ or
Vol-. The bar will disappear after a predefined time following the last
Vol+ or Vol- key press. Automatically removed after 2 seconds.
3) Mute Symbol
Pressing the Mute key mutes the sound and a symbol is displayed,
Automatically removed after 2 seconds.
4) Screen Freeze
Pressing the Pause key will Freeze the Screen and a pause symbol
will be displayed. Press the Pause key again to exit Freezing.
5) Direct Digit Entry
When the user initiates a channel change using the number keys,
The user can press the OK key to force the channel change before
all 3 digits have been entered. If all 3 digits are entered then the
channel change will occur.
5 seconds after the last key press, the channel change will be
initiated if all digits have not been entered.
6) TV/Radio select
Press TV/Radio button on the remote to toggle between TV channels
and Radio stations, then you can change among the TV channels or
Radio stations by pressing CH+/- buttons. This mode can be
removed later if you select a channel by Direct Digit Entry or Service
Organiser.
5
3