Original Instruction 40V LITHIUM-ION CORDLESS LAWN MOWER Operator’s Manual and Part List WARNING Read this instruction manual before use Keep bystanders away Beware of sharp blades Blade continues to rotate after blade is switched off Always remove the battery and isolation key before storage or service MADE IN CHINA 1 / 17...
Original Instruction CONTENTS • Contents…………………………………… ….….… ……2 • Specifications……………………………………….……..3 • Symbols……………………………………………….…...4 • Major Part of the Lawn Mower…………………….…….5 • Safety Instructions………………………………….……6-9 • Assembly and Operation……..……………………..…10-14 • Exploded View and Part List ….. …………………..…15-16 • EC Declaration of Conformity……………………………17 2 / 17...
Original Instruction SYMBOLS Warning, safety alert. Read and follow all safety precautions in the operator’s manual. Do not expose machine to rain or wet conditions Keep hands and feet away Keep bystanders away. Pay attention to avoid injury to bystanders by objects thrown by the blade Keep hands and feet away from blade and cutting area.
Original Instruction MAJOR PARTS OF THE LAWN MOWER FIG 1. Power Switch (4 switches, 2 on each side of the handle) Safety switch 3. Upper handle clamp 4. Grass collection box 5.Lower handle clamp 6. Carry handle 7.Cutting height lever 8.
Original Instruction SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS WARNING: When using electric lawn mowers basic safety precautions should always be followed to reduce the risk of fire electric shock, including the following. Risk of injury could occur if the lawn mower is operated without the catcher assembly attached WARNING: The use of any other accessory or attachment might increase the risk of injury CAUTION: F or battery-operated lawn mowers use only identical replacement batteries and specifying the battery...
Page 7
Original Instruction b) Do not use battery-operated lawn mower in rain. c) When replacing batteries, all batteries should be replaced at the same time. Mixing fresh and discharged batteries could increase internal cell pressure and rupture the discharge battery (Applies to products employing more than one separately replaceable primary battery.) For a battery-operated lawn mower employing a vented wet cell battery supply intended to be initially or periodically filled by the user:...
Original Instruction a)1.Mow across the face of slopes; never up and down. Exercise extreme caution when changing direction on slopes. b)Watch for holes, ruts, bumps, rocks. or other hidden objects. Uneven terrain could cause a slip and fail accident. Tall grass can hide obstacles.
Page 9
Original Instruction 1.2 Operation Do not put hands or feet near or under rotating parts. Keep clear of the discharge opening at all times. Stop the blade(s)when crossing gravel drives, walks, or roads. After striking a foreign object, stop the motor, unplug, thoroughly inspect the mower for any damage, and repair the damage before abnormally and operating the mower.
Original Instruction ■ Operator’s manual UNFOLDING AND ADJUSTING HANDLE 1. Pull up and back on the upper handle to raise the handle into operating position. Make certain the base of the handles snap into place securely. 2. Tighten the upper handle with screws on both sides. 3.
Page 11
Original Instruction INSTALLING E GRASSBOX Always use the grass box when using this lawn mower. 1. Lift the rear discharge door. 2. Lift the grass box by its handle and place under the rear door, so that the hooks on the grass box frame are seated into the slots provided in the handle bracket.
Original Instruction 6. Close the battery door. Battery condition can be checked at any time by pressing the button on the handle-mounted fuel gauge (item 10 Fig1). Fuel Gauge TO REMOVE BATTERY PACK 1. Release the power switch to stop the mower. Remember that it takes a few moments for the blades to stop turning 2.
Original Instruction 15° ADJUSTING THE CUTTING HEIGHT Use the cutting height lever (item 7 Fig1) to adjust the cutting height. This single lever will adjust the height of all wheels. There are five cutting heights to choose from Pull the cutting height lever sideways and push forwards to increase cutting height and pull backwards to increase height.
Page 14
Original Instruction BATTERY CHARGER Battery Charger WARNING: This charger can be used with an input voltage of 100-250V and an AC frequency of 50-60Hz. To avoid the risk of damage and injury, only use the charger to recharge Redback 40V battery packs. Never try to recharge non-rechargeable batteries.