Advertisement
Advertisement
Table of Contents
Summary of Contents for Texsun El Niño
- Page 1 INSTRUCTIONS...
- Page 2 Easy to Assemble El Niño solar collector for garden pools are delivered ready to assemble to your pools circulation pump.The system is equipped with a by-pass connection that allows you to switch the collectors “on and off” to avoid over heating.The by-pass collectors can also be used to regulate the water flow in case an over-dimensioned pump is used.
- Page 3 Measuring the Flow Rate The flow rate is meassured by: 1. Open up the the by-pass valve 2. Putting the return hose in a volume vessel. Read the volume after 1 minute 3. Slowly close the by-pass valve until a flow of 4-10 liters/minute has been achieved (NOTE: most circulation pumps delivered with small above-ground pools do not give a higher flow rate than recommended.Therefore, most of the...
- Page 4 Setting up Your El Niño 1. On the ground next to the pool 2. On a simple stand – tilt the stand 0-30 degrees 3. Vertically mounted – remember that the pumps lifting capacity will limit the maxi- mum height of the installation El Niño will have the best efficiency if located: •...
Need help?
Do you have a question about the El Niño and is the answer not in the manual?
Questions and answers
Hej! Vi har en badtunna som drivs med gasol. Men, vi har en oanvänd solpanel (Texsun el nino) som vi vill kunna använda. Vilken pump eller dyl behöver vi komplettera med? Hur får vi den att värma vår pool? Tacksam för snabbt svar! Mvh Annica Bergström
The Texsun El Niño solar panel is intended for use with the existing pool pump. A separate pump is not included or required.
This answer is automatically generated