Speed Change; Depth Gauge - Makita DP4010 Instruction Manual

Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.

Speed change

1
2
002691
Two speed ranges can be preselected with the speed
change knob.
To change the speed, turn the speed change knob so
that the arrow on the tool body points toward the "I"
position on the knob for low speed or "II" position for
high speed.
If it is hard to turn the knob, first turn the chuck slightly
in either direction and then turn the knob again.
CAUTION:
Use the speed change knob only after the tool
•
comes to a complete stop. Changing the tool
speed before the tool stops may damage the tool.
Always set the speed change knob to the correct
•
position. If you operate the tool with the speed
change knob positioned halfway between the "I"
and "II" position, the tool may be damaged.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
1
3
2
4
002693
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel.
Then tighten the grip by turning clockwise at the desired
position.
1. Arrow
2. Speed change
knob
1. Grip base
2. Side grip
(auxiliary
handle)
3. Teeth
4. Protrusions
5
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing.
Installing or removing drill bit
For Model DP4010
002694
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the
original position.
For Model DP4011
1
2
002695
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the bit in the chuck as far as
it will go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.

Depth gauge

1
002696
1. Chuck key
1
1. Sleeve
2. Ring
1. Depth gauge