Mitsubishi Electric MSZ-GE22VA Installation Manual

INSTALLATION MANUAL

1. BEFORE INSTALLATION

1-1. THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFETY
• Be sure to read "THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFETY" before installing the air conditioner.
Do not install the unit by yourself (user).
Perform the installation securely referring to the
installation manual.
Install the unit securely in a place which can bear
the weight of the unit.
If the installation location cannot bear the weight of the
manual. Be sure to use an exclusive circuit. Do not
connect other electrical appliances to the circuit.
Do not damage the wires by applying excessive
pressure with parts or screws.
Be sure to cut off the main power in case of setting
up the indoor P.C. board or wiring works.
the terminal block connecting sections so the stress
of the wires is not applied to the sections. Do not
Earth the unit correctly.
ning rod or telephone earth. Defective earthing could
Install an earth leakage breaker depending on the
installation place.

1-2. SELECTING THE INSTALLATION LOCATION

INDOOR UNIT
• Rigid wall without vibration.
fected device.
REMOTE CONTROLLER
• Where children cannot touch it.

1-3. SPECIFICATIONS

Indoor unit Outdoor unit
Model names are indicated in 1-3.
unit for outdoor unit installation.
gas may leak.
Do not use intermediate connection of the power
cord or the extension cord and do not connect
many devices to one AC outlet.
for the installation work.
parts in both the outlet and the plug. Make sure that the
power supply plug is pushed completely into the outlet.
Attach the electrical cover to the indoor unit and the
service panel to the outdoor unit securely.
If the electrical cover of the indoor unit and/or the service
ant (R410A) enters the refrigerant circuit.
Perform the drainage/piping work securely accord-
- ing to the installation manual.
hold goods.
the outdoor unit.
Note:
received.
OUTDOOR UNIT
-
possible.
or hot air.
• Where rigid wall or support is available to prevent the
increase of operation sound or vibration.
the unit legs.
-
-
-
Rated
Voltage
Level
Scale
Torque wrench
WARNING
-
-
-
-
-
CAUTION
-
Indoor/outdoor
Gas / Liquid
connecting wire
3-core
3-core
Required Tools for Installation
Do not discharge the refrigerant into the atmosphere. If
could be generated.
Check that the refrigerant gas does not leak after
installation has been completed.
Use appropriate tools and piping materials for installation.
pressor before disconnecting the refrigerant pipes.
frigerant pipes before starting the compressor.
could be drawn in and the pressure in the refrigeration
in this manual.
The unit shall be installed in accordance with na-
tional wiring regulations.
Do not install the outdoor unit where small animals
may live.
unit clean.
Note:
Note:
• Never install the outdoor unit in a place where its air
with its air inlet side facing the wall.
•
Avoid the following places for installation where air condi-
tioner trouble is liable to occur.
-
-
-
-
-