Martin Audio M3 User Manual page 6

<
CONTENTS
7
There are many different system combinations possible with the blackline
series. Shown below are some typical configurations. Please note that for
simplicity only the left channel is shown.
7.1
7.1.1 F12/F15 Full-range
Mode Switch Full-range (Red LED)
J7, J8, J9, J10 IN
J15, J16 POSITION 'A'
Figure11.
J17 POSITION 'A'
Left In
7.1.2 F12/F15 Full-range with add-on S15/S18 sub-bass
This provides a simple way of increasing bass performance without the
need for an additional amplifier. The switch at the rear of the sub-bass
enclosure should be switched to "passive" and a link lead run from the
sub-bass to the F12/F15. This configuration will present a 4 ohm load to
the amplifier.
Mode Switch Full-range (Red LED)
J7, J8, J9, J10 IN
J15, J16 POSITION 'A'
J17 POSITION 'A'
Figure12.
Left In
>
PRINT
M3 SYSTEM CONFIGURATIONS
Passive systems
Optional M3 Controller
M3-F12-F15
Optional M3 Controller
M3-F12-F15SP
Martin Audio – M3 System Controller
M3-F12-F15
Ch2 Out
Amplifier
M3-F12-F15SP
Ch2 Out
Amplifier
6
GUIDES
F12/F15
F12/F15
S15/S18