SUPERTOOTH buddy Manual page 6

actions (voice dial, redial) will control the primary phone, but an incoming call
on any of the two phones can be accepted or rejected from the SUPERTOOTH
BUDDY.
Multi-Point Activation:
From pairing mode or standby mode, press and hold the Volume Up (2).
A beep will be heard on kit.
Multi-Point Deactivation:
From pairing mode or standby mode, press and hold the Volume Down (3).
A beep will be heard on kit.
Multi-Point Pairing Procedure:
1. Turn off the handsfree kit by pressing and holding the On/Off (8) button
until the LED flashes red.
2. Pair the additional phone as explained in "Pairing to your Bluetooth
Mobile Phone on section E". This phone will now be the primary phone.
3. Connect the 1
connect both phones automatically.
Using Multi-Point:
Refer to "BASIC OPERATION on section G".
Notes:
• Voice dial and re-dial will be done using the primary phone only.
• You can accept or reject calls from any of the two phones.
When you already have an ongoing call on the 1
nd
on the 2 phone, you will hear a special ringtone on the handsfree kit while the
ongoing communication continues.
st
To end the 1 phone call and accept the 2
Short press the MFB (6) button will automatically end the 1
nd
accept the 2
handsfree kit).
Note: Call waiting is not available if two phones are connected (MultiPoint).
c. Switching Connections Between Paired Phones
The SUPERTOOTH BUDDY always maintains a maximum of 8 phones in its
memory. An additional pairing will automatically delete the phone that has not
been used for the longest time. This phone needs to be paired again before it
can be used.
You can easily switch to any of the paired phones by:
st
phone paired manually or turn the kit Off then On to
phone call (audio will automatically be heard through the
st
phone, if you receive a call
nd
phone call:
5
st
phone call and