AT-24
AUTOMATIC TRANSMISSION - COMPONENT PARTS REMOVAL
26. REMOVE FRONT CLUTCH ASSEMBLY
(a)
Place SST, on the installation surface of the oil pump.
SST 09350-36010(09350-06090)
(b)
Using calipers, measure the distance between the
tops of SST and the clutch drum for assembly.
(c)
Remove the front clutch assembly.
(d)
Remove the race and thrust bearing from the rear
clutch drum or front clutch hub.
27. REMOVE REAR CLUTCH ASSEMBLY
Install two wires into flukes of the clutch discs, and
remove the rear clutch assembly.
28. CHECK THRUST CLEARANCE OF CENTER SUP-
PORT, AND REMOVE CENTER SUPPORT ASSEM-
BLY
(a)
Push the transmission output shaft toward the front
of the transmission by applying a force of 49 — 98 N (5
- 1 0 kgf, 11.0-22.0 Ibf).