Installing / Removing Battery Pack - Black & Decker LGC120 Instruction Manual

3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights.
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 60°F and 80°F
(16°- 27°C)
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the charging
procedure. You may also charge a partially used pack whenever
you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited
to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
Shock hazard. Do not allow any liquid to get
inside charger. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks,
return to a service center for recycling.
INSTALLING / REMOVING BATTERY PACK
WARNING:
Make certain the
lock-off button is engaged to prevent
switch actuation before removing or
installing battery.
TO INSTALL BATTERY PACK:
Insert battery pack into tool until an
audible click is heard (figure B).
TO REMOVE BATTERY
PACK: Depress the battery release
B
button in the back of the battery pack and pull battery pack out of
tool (figure B).
AUxILIARY HANDLE ASSEMBLY (FIG. C)
• Position handle on upper tube to desired height.
• Ensure locking block (8) is aligned with groove in tube.
• Assemble and tighten bolt (9).
C
8
POLE ExTENSION (FIG. D)
• Loosen collar (10).
• Extend poles to desired length.
• Tighten collar.
7
ASSEMBLY
9
D
10