Checking Coolant Level - Mercedes-Benz SL 320 Operator's Manual

Example

Checking Coolant Level

The coolant level can be checked
visually at the transparent coolant
reservoir.
To check the coolant level, the vehicle
must be parked on level ground.
Check coolant level only when coolant
is cold:
The coolant should reach the rib in the
filler neck. Also see marking (1) on
reservoir.
Warning!
• Use extreme caution when
opening the hood if there
are any signs of steam or
coolant leaking from the
cooling system.
• Do not remove pressure cap on
coolant reservoir if engine
temperature is above 194 °F
(90 °C). Allow engine to cool down
before removing cap. The coolant
reservoir contains hot fluid and is
under pressure.
• Using a rag, turn cap to first
notch to relieve excess pressure.
If opened immediately, scalding
hot fluid and steam will be blown
out under pressure, possibly
causing personal injury.
• Do not spill antifreeze on hot
engine parts. Antifreeze contains
ethylene glycol which may burn if
it comes into contact with hot
engine parts. You can be seriously
burned
Adding Coolant
If coolant has to be added, a 50/50
mixture of water and MB
anticorrosion/antifreeze should be
added.
SL 320:
The drain plugs for the cooling system
are located on the right side of the
engine block and at the bottom of the
radiator.
SL 500, SL 600:
The drain plugs for the cooling system
are located on the right and left sides
of the engine block and at the bottom
of the radiator.
Anticorrosion/antifreeze, see
Coolants in Index.
97