Advertisement
GLX LED STAGE 4 MANUAL
Thanks for choosing the GLS-4-MOD lighting system. In order to make the best use of your LED
SYSTEM, please read the following carefully.
Important notes
1. Read these instructions.
2. Keep these instructions.
3. Do not use the GLS-4-MOD near water.
4. Clean only with dry cloth.
5. Install in accordance with the manufacturer's instructions.
6. Do not block any ventilation openings.
7. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
8. Protect the power cord from being walked on or being pinched.
9. Unplug this apparatus when unused for long periods of time.
There are no user serviceable parts inside. All servicing has to be done by qualified service personnel.
Servicing is required when the GLS-4-MOD has been damaged in any way, such as when the power
supply cord or plug is damaged, when objects have fallen onto the GLS-4-MOD, when it has been
exposed to rain or moisture, or when the GLS-4-MOD does not operate normally.
Warning: damages caused by the disregard of this user manual are not subject to warranty.
Installation of the GLS-4-MOD
The GLX Lighting LED stage 4 modular led system holds:
4 seperate spots
1 PCB module with display
1 controller
Connect the spots and the controller to the module and plug in the power cord. The GLS-4-MOD starts
running in automatic mode. The spots and the module can be placed on a crossbar, lighting stand or
truss. Please note: for overhead rigging in public or industrial areas, a series of safety instructions have
to be followed that this manual can only give in part.
Main connection
The device must only be connected in compliance with the IEC standards. The electric installation must
be equipped with a Residual Current Device (RCD) with a maximum fault current of 30mA. Lighting
effects must never be connected to dimming packs.
Operation
After you power up the GLS-4-MOD, the LED's start running and the display lights up. The device has
two operating modes; it can be operated in sound controlled or in DMX-controlled mode.
You can choose the desired mode via the button MENU, UP and DOWN:
When the display shows A*** you can choose the desired DMX address via the UP or DOWN buttons.
When the display shows *512 the device is in DMX mode. To switch to sound controlled mode, press
the DOWN button.
When the display shows *SND the device is in sound controlled mode. To switch to DMX mode, press
the UP button.
When the display shows S** you can choose the desired speed of the internal programs. Default is 51;
for increasing speed press the DOWN button, for decreasing speed press the UP button.
2
Advertisement
