Page 1
Quick Installation Guide Direct and Transfer Thermal Printer Overview The enclosed printer is currently comprised of two models: 203dpi (dots per inch) model 300dpi (dots per inch) model Unpacking 1. Remove top foam packing piece. 2. Lift printer straight up out of box. 3.
Installation 1. Determine a suitable location for the printer with the following Media Viewing Window requirements: Flat stable surface with sufficient clearance to allow for interface cables and media loading. FEED / CONFIG. Free from excessive direct sunlight, temperature, humidity, dust, dirt, and debris.
Loading Media 1. Fully open Media Access Cover. Media Access 2. Open the Front Access Door by Cover rotating down. 3. Rotate the green Printhead Latch counterclockwise open printhead. 4. Rotate the Side Access Door down to allow the media to be loaded under the printhead module.
Page 4
15. Grasping the Sensor Adjust Knob and sliding it in or out as needed can move the Media Sensor. This is required only if the sensor must be moved to a specific location on the label to detect a notch (hole) or gap. 16.
Loading Ribbon Ribbon Ribbon Path Selector Take-Up Supply Knob (Pull Roll Roll 1. If needed, follow steps 1-4 under and Slide) Loading Media section. 2. Unwrap the ribbon and place the Ribbon Supply Roll on the Ribbon Ribbon Take-Up Supply Spindle located towards Spindle back of printer.
Installing Windows Drivers User Selectable Features Windows drivers are included with each printer printer NOTE: Features are subject to change depending on printer model. installation setup, as required for the Feature Description version Windows you are using. Print Mode Direct Thermal Thermal Transfer Auto Calibrate Mode Mode 1~4...