Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Martin MC-1
- Page 1 MC-1 user manual...
-
Page 2: Safety Precautions
This user manual describes the features programmed in firmware version 1.1. SAFETY PRECAUTIONS The MC-1 is not for household use. For safe operation, read this manual before use and follow the safety precautions listed below. If you have questions about how to operate the controller safely, please contact your Martin distributor or dealer. - Page 3 UNPACKING The MC-1 comes with: • 1.5-meter IEC power cable • 5-meter 3-pin XLR data cable • 3-pin male XLR termination plug • user manual...
-
Page 4: Ac Power Connection
MC-1 SETUP AC POWER CONNECTION Warning! For protection from electric shock, the fixture must be grounded (earthed). The AC mains supply shall have overload and ground-fault protection. The fixture’s mains lead must be fitted with a grounding-type co rd cap th at fits your powe r distribution cable or outlet. -
Page 5: Data Connection
Your Martin dealer can supply suitable cable in various lengths. The MC-1’s data output, which is wired pin 1 to ground, pin 2 to signal - (cold), and pin 3 to signal + (hot), is configured for direct connection to all MC-1 compatible Martin fixtures. - Page 6 IXTURE SETUP FULLY COMPATIBLE FIXTURES Fully compatible Martin fixtures automatically detect the MC-1 and no DIP-switch setting is required for factory-default operation. Optional fixture settings may be available to modify behavior and create more varied light shows. These options are set using the fixture’s DIP-switch; refer to the fixture manual for details.
- Page 7 MC-1. Though synchronized control and special options are not available, the MC-1 may be used to control some or all of the fixtures’ 1-channel DMX mode functions. Partially compatible fixtures must be set to 1-channel DMX mode and addressed to channel 1 as described below.
- Page 8 This section describes the operating features available with fully compatible fixtures. To control l ight s with t he MC-1 Set up the MC-1 and the lights as described in the previous sections. Apply power to the MC-1 and the fixtures. Allow the fixtures to reset.
-
Page 9: Troubleshooting
Fixtures respond to Damaged Refer fixture for blackout and manual microphone or other service if problem trig but not to music. component. occurs in stand-alone modes. Refer MC-1 to service if it occurs in Music trig mode. -
Page 10: Specifications
A C P O W E R • Input ..........3-prong IEC male socket • Maximum power and current ....see serial number label A C C E S S O R I E S • 3U 19 inch rack mount kit for MC-1....P/N 91613019...