JBL a12 Operating Instructions Manual page 29

DELETE
With one step of the sequence can be deleted. Chose the step and confirm the
function with ENTER.
To reset the DMX values of a step use
"ENTER". All DMX values of the step will be set on zero.
CLEAR ALL
With the complete sequence will be deleted and the display will show
STEP 01/01.
Store cues from a DMX board:
The DMX values can also be programmed by means of a DMX console.
STANDALONE
Enter the
with an external DMX-console. To capture the data press „ENTER". The fixtures display
START CAPTURE
will show
of the fixture.
Activate the standalone mode:
The standalone mode is activated in the menu
To enter the functions press "ENTER" (keep it down) and press "ESC" in addtion.
The A12 will execute sequence in a repeating loop.
To leave press "ESC" and hold it down and press "ENTER" in addition.
Operation in Master-Slave mode:
To set a fixture to slave-mode navigate to
To activate the slave funciton p
The display will show either REMOTE INACTIVE if no DMX-signal is being
received or REMOTE ACTIVE if a DMX-signal is being received.
To leave this fuction press "ESC" (keep it down) and press "ENTER" in addition.
Connect the A12 with DMX cables.
STANDALONE/RUN
Select
(keep it down) and pressing "ESC" in addition.
All connected fixtures will repeat the steps synchronized to the master fixture.
To leave the menu press "ESC" (keep it down) and press "ENTER" in addition.
If you realize that a fixture reacts inaccurate check if the display shows REMOTE ACTIVE.
RESET STEP
menu and navigate to
. To insert, delete or reset use the keys of the control panel
REMOTE.
ress "ENTER" (keep it down) and press "ESC" in addtion.
with the master fixture. Start function by pressing "ENTER"
. Select the step and confirm with
CAPT DMX
. Programm the DMX-values
STANDALONE, RUN.
29