Id Recall; Volume Punch Through; Master Power; Menu Mode - Tek Partner BW-0561-RD Product Manual

ID Recall

Device mode (3 seconds)  MENU/PREV.
CH (RECALL)
The ID Recall function will show you the
code for the device that you've already
programmed.
1. On the remote control, press and hold the
applicable device mode button ([TV] [VCR]
[DVD] [CBL/SAT]) until the indicator light in
the upper left-hand corner begins to blink
(approximately 3 seconds).
2. As soon as the indicator light begins to blink,
release the device mode button.
3. On the remote control, press and release the
MENU/PREV. CH (RECALL) button.
4. As soon as you release the MENU/PREV. CH
(RECALL) button, the indicator light in the upper
left-hand corner will show you the code for your
device by blinking the 100's, 10's and 1's of your
code.
5. Count the number of blinks to determine the
code. A '0' in any location is represented by a
Example: Code 102 is shown as BLINK <pause> FLICKER
<pause> BLINK, BLINK.

Volume Punch Through

Device mode (3 seconds)  Device mode
(hold)  TV
The Volume Punch Through function allows
you to change the volume on your TV while
in CBL/SAT, DVD or VCR mode.
1. Program the remote control to your TV and other
media devices.
2. On the remote control, press and hold the
applicable device mode button ([CBL/SAT], [VCR],
[DVD]) until the indicator light in the upper left-
hand corner begins to blink (approximately 3
seconds).
3. As soon as the indicator light begins to blink,
release the Device mode button.
4. On the remote control, press and hold the same
device mode button again and then also press and
hold the [TV ] button at the same time.
5.
release both buttons.

Master Power

Device mode (3 seconds)  PWR  PWR
The Master Power function allows you to
turn the power on or off for all programmed
devices at the same time.
1. Program the remote control to all of your
devices.
2. Power on all of your devices.
3. On the remote control, press and hold the device
mode button ([TV] [VCR] [DVD] [CBL/SAT]) until
the indicator light in the upper left-hand corner
begins to blink (approximately 3 seconds).
(Use [CBL/SAT] at Step 3 if you have cable or
satellite devices.)
4. As soon as the indicator light begins to blink,
release the device mode button.
5. On the remote control, press and release the
PWR button.
6. Again, on the remote control, press and release
the PWR button.
7. To disable Master Power, repeat the steps above.

Menu Mode

The Menu Mode allows you to use the blue
arrow buttons (   ) to navigate a
programmed device.
1. Program the remote control to all of your
devices.
2. Press and release the MENU/PREV. CH
(RECALL) button.
3. In Menu Mode, use arrow buttons (   ) to
navigate.
4. Once the desired menu item is reached, press
and release the ENTER (SELECT) button to
select it.
NOTE: If any button other than     or ENTER
(SELECT) is pressed or if no buttons are pressed within 20
seconds, the remote control will exit Menu Mode.
4