Air-Plus 691164 Operation Manual page 6

USE COMBUSTIBLE GASSES OR ANY OTHER REACTIVE GAS AS A POWER
SOURCE FOR THIS NAILER/STAPLER. Explosion and serious personal injury
could occur.
• Use clean, dry, regulated, compressed air at 60 to 100 PSI (0.4 to 0.7 MPA). Do
not connect the nailer/stapler to any pressure source that may exceed 120 PSI
(0.8 MPA).
• Only use air hose that is rated for a maximum working pressure of at least 150
PSI (1.0 MPA) or 150% of the maximum system pressure, whichever is greater.
• Always disconnect the nailer/stapler to the air supply before loading fasteners.
• Disconnect nailer/stapler from the air supply hose before unloading fasteners, performing nailer/stapler
maintenance, clearing a jammed fastener, leaving work area, moving nailer/stapler to another location,
or handing the nailer/stapler to another person.
• Always assume that the air nailer/stapler is loaded with fasteners. Never point air nailer/stapler at any
part of your body or at others in the work area.
• Never use nailer/stapler if safety, trigger or springs are inoperable, missing or damaged. DO NOT alter
or remove safety, trigger or springs. Make sure that there is free movement of the trigger and safety
mechanism before each use.
• Do not load fasteners with trigger or safety depressed to prevent unintentional firing of a fastener.
• Do not drive fasteners close to the edge of the work piece. The work piece is likely to split allowing fas-
teners to fly free or ricochet causing personal injury.
• Fire fasteners into work surface only. Never fire into materials that are too hard
to penetrate. DO NOT drive fasteners in on top of other fasteners or with the
nailer/stapler at too steep an angle as the fasteners may ricochet causing per-
sonal injury.
• Always carry a fastener-driving nailer/stapler by the handgrip and never by the
trigger or with the trigger activated. Never carry the nailer/stapler by the hose or
pull the hose to move the nailer/stapler.
READ ALL OPERATING INSTRUCTIONS BEFORE
Preparing the Nailer/stapler for Operation:
• This air nailer/stapler requires lubrication for proper operation and service life. Failure to lubricate nail-
er/stapler properly will result in damage to the nailer/stapler and void your warranty.
• Lubricate before first use and before each work session thereafter.
• Disconnect the air supply from the nailer/stapler before lubricating.
• Add a few drops of nailer/stapler 30W non-detergent oil into the inlet. Wipe off excessive oil at the
exhaust. Excessive oil will damage the o-rings of the nailer/stapler. Never use detergent oil, or oil
additives. Do not use air oi, as it contains solvents which will damage the nailer/stapler's internal com-
ponents.
• Note: If an in-line oiler is used, manual lubrication through the air inlet is not required on a daily basis.
OPERATING INSTRUCTIONS
USING AIR NAILER/STAPLER
6