Battery charger single phase 12v/24v 30a (8 pages)
Summary of Contents for Rossi CD-230P
Page 1
User Manual ROSSI Chargers WARNING! Read and understand all safety warnings and instructions carefully before using this machine. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save this manual for future reference.
Index Index ................................1 Safety ................................2 Parts Diagrams ............................. 5 Assembly (CD-230P, CD-280P & CD-430P models) ..................7 Using your Charger ............................8 Charging Mode output (1, 2 & BOOST, MIN options) ....................8 Charging ..................................8 Battery is installed in a vehicle ............................9 Battery removed / away from vehicle ..........................
Product Manual – Battery Charger / Starter Safety t is important you read Do not operate the charger with a DANGER! Exposure to fumes and understand the damaged cord or plug; have the cord and gases can damage the instruction manual before or plug replaced immediately by a lungs and respiratory system use and keep the manual...
Page 4
Product Manual – Battery Charger / Starter cautionary markings these batteries may burst and cause injury battery, vehicle and any equipment products and on the charger. to persons and damage to property. used near the battery and charger. Study battery manufacturer’s WARNING! Do not use with non- WARNING! NEVER charge a...
Product Manual – Battery Charger / Starter Assembly (CD-230P, CD-280P & CD-430P models) Note! The GZL-30P does not require any assembly. 1. Lay the charger down on a flat stable surface so you can access the undercarriage. 2. Slide the steel “axle shaft” into the axle holder on the bottom of the charger leaving some of the shaft protruding (around 50mm).
Product Manual – Battery Charger / Starter Using your Charger WARNING! Monitor the charging progress and stop it when the battery is charged. Not doing so may cause damage to your battery or may cause other personal property damage or personal injury. 1.
Product Manual – Battery Charger / Starter You may select the output voltages of 12 or 24 volts for charging the batteries of those voltages or battery combinations connected in series (not parallel) in which the sum of the battery voltages adds up to the range selected. IMPORTANT! Consult an alternative power expert before using this charger to charge multi battery installations.
A marine (boat) battery must be removed and charged on shore. Using the Engine “Jump Start” feature CD-230P, CD-280P & CD-430P models only. Your battery charger can be used to jumpstart your car if the battery is low. Follow these instructions on how to use the ENGINE START feature.
Product Manual – Battery Charger / Starter NOTE: If the engine does turn over but never starts, there is not a problem with the starting system; there is a problem somewhere else with the vehicle. STOP cranking the engine until the other problem has been diagnosed and corrected.
Product Manual – Battery Charger / Starter Fuses CD-230P, CD-280P & CD-430P models 100 Amp Fuse – Replace the fuse with 2 of the supplied 50Amp blades or use 2 strands of 50Amp fuse wire (doubled) to make 100Amp. GZL30P models...
Product Manual – Battery Charger / Starter Transporting & Storage Store the charger unplugged, in an upright position. The cord will still conduct electricity until it is unplugged from the outlet. If the charger is moved around the shop or transported to another location, take care to avoid/prevent damage to the cords, clips and charger.
Need help?
Do you have a question about the CD-230P and is the answer not in the manual?
Questions and answers