Advertisement
FRONT PANEL
1
2
The AG60 Acoustic Performance system is designed for up to four inputs which can be any combination of
microphones, and channel 2 for instruments. The EQ and effects can be tailored for each channel independently.
microphone into any input in either channel.
acoustic instrument has a preamp, you should set the volume control on your instrument at about half volume.
You can then adjust the amplifier volume to your normal playing level and still have room to increase or
decrease your volume as needed from the instrument.
3. Low frequency control set to boost (15 dB) or cut (-15 dB) frequencies at 80 Hz. Controls the lowest fundamental
frequencies to enhance the warmth and deep, full tones of your acoustic instrument.
4. Midrange frequency control set to boost (15 dB) or cut (-15 dB) frequencies that you can sweep between
500Hz and 1.2kHz. Moving the midrange frequency and either cutting or boosting this frequency will give you
maximum control over the body of your tone. This control can also be useful in eliminating acoustic feedback. It
also allows you to control the definition and voice of your acoustic instrument.
5. High control set to boost (15 dB) or cut (-15 dB) frequencies at 10 kHz. Increasing this will enhance the clarity
and brightness of your acoustic instrument.
6. The Effect level control Is used to determine how much of the selected effect is applied to your music. Each
channel has an independent Level control for the effects.
7. The Effect Select control for each channel allows you to select from one of 16 different effects including reverbs,
delays, choruses and combinations of the above. The 16 effects are detailed around the face of the knob on the
AG60. A unique and useful feature is that a different effect can be selected for Channels 1 and 2.
8. The Master Level controls the overall stage volume of the amplifier. Changing this level control will not affect
the line out levels on the back of the amplifier, therefore will not change your signal sent to a live or recording
mixing console.
play along. This input has a separate level control which allows for fine tuning of the input signal.
10. Power LED. This light will illuminate with a soft blue color when the amp is turned on and ready to play
6
w w w . a c o u s t i c a m p l i f i c a t i o n . c o m
1
2
3
6
4
5
7
8
9
10
11
Advertisement
