Hazard Warning Flashers; Turn And Lane-Change; Signals - Cadillac XTS 2015 Owner's Manual

Hide thumbs Also See for XTS 2015:
Table of Contents

Advertisement

Cadillac XTS Owner Manual (GMNA-Localizing-MidEast-8087803) - 2015 -
crc - 6/24/14
To enable AFL, set the exterior lamp
control to the AUTO position.
Moving the control out of the AUTO
position will deactivate the system.
AFL will operate when the vehicle
speed is greater than 3 km/h
(2 mph). AFL will not operate when
the transmission is in R (Reverse).
AFL is not immediately operable
after starting the vehicle; driving a
short distance is required to
calibrate the AFL. See Exterior
Lamp Controls on page 6-1.
Curve Lighting
The light beam pivots based on the
steering wheel position and vehicle
speed of at least 10 km/h (6 mph).
The headlamps shine at an angle of
up to 15 degrees to the right or left
of the direction of travel.

Hazard Warning Flashers

(Hazard Warning Flashers):
Press this button on the center
stack to make the front and rear turn
signal lamps flash on and off. Press
again to turn the flashers off.
The hazard warning flashers turn on
automatically if the airbags deploy.
Black plate (5,1)
Lighting

Turn and Lane-Change

Signals

Move the lever all the way up or
down to signal a turn.
An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.
Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Hold it there until the lane
change is completed. If the lever is
briefly pressed and released, the
turn signal flashes three times.
6-5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents