Back Up Batteries; Dimmer Function; How To Set Correct Time; Alarm Function - Nero 7433301 Operating Instructions Manual

- INSERT THE PLUG OF THE AC-ADAPTOR INTO A WALL OUTLET WITH AC-POWER.
- PRESS THE "ON/OFF" KEY TO SWITCH ON THE UNIT.
- THIS UNIT IS DESIGNED TO OPERATE WITHOUT EVER BEING TOTALLY POWERED
"OFF".
IT WILL EITHER BE "ON" OR IN "STANDBY MODE".
- IN STANDBY MODE, THE BACK-LIGHT OF THE DIGITAL DISPLAY WILL BE DIMMED
BUT THE DISPLAY WILL SHOW THE CURRENT TIME (CLOCK FUNCTION).
- ANYTIME DURING STANDBY MODE, YOU CAN SWITCH "ON" THE UNIT BY PRESSING
THE "ON/OFF" KEY.
- SAVE ENERGY BY SWITCHING THE SYSTEM TO "STANDBY" MODE WHEN NOT IN
USE.

BACK UP BATTERIES

- OPEN THE BATTERY DOOR AT THE BOTTOM OF UNIT.
- INSERT 2 PCS "AAA-CELL" (UM-4/LR03 TYPE) BATTERIES IN THE BATTERY
COMPARTMENT.
THESE 2 BATTERIES ARE FOR BACKUP OF THE CLOCK DURING BRIEF POWER
OUTAGES.

DIMMER FUNCTION

THIS SET HAS A DIMMER FUNCTION TO ADJUST THE BRIGHTNESS LEVEL
OF THE DISPLAY BACKLIGHT. SIMPLY ADJUST IT AS DESIRED BY PRESSING
THE SNOOZE/DIMMER KEY REPEATEDLY (HI-BRIGHTNESS/LOW-BRIGHTNESS/OFF).
THE DISPLAY BACKLIGHT WILL ALWAYS RETURN TO HI-BRIGHTNESS AS THE DEFAULT,
AFTER THE UNIT BEEN RESET.
DIGITAL CLOCK FUNCTION
- THE SET HAS A BUILT-IN DIGITAL CLOCK.
(THE DISPLAY WILL CONTINUOUSLY SHOW THE CURRENT TIME).

HOW TO SET CORRECT TIME:

1. SWITCH UNIT TO "STAND-BY" MODE
2.
PRESS & HOLD FUNC./CL-SET KEY FOR 3 SECONDS DISPLAY SHOWS
HOUR OR
3. PRESS SKIP-
24-HOUR CLOCK DISPLAY SYSTEM & PRESS FUNC./CL-SET KEY TO CONFIRM YOUR
SELECTION.
4.
PRESS SKIP-
THE CORRECT HOUR IN THE DISPLAY & PRESS FUNC./CL-SET KEY TO CONFIRM.
5.
PRESS SKIP-
THE CORRECT MINUTE IN THE DISPLAY & PRESS FUNC./CL-SET KEY TO CONFIRM.
6. CORRECT TIME IS NOW SET & WILL BE SHOWN IN THE DISPLAY.

ALARM FUNCTION

- THIS SET IS EQUIPPED WITH 2 ALARM MODES: BUZZER AND RADIO.
BEFORE SETTING THE ALARM, BE SURE TO SET THE CLOCK (SEE "DIGITAL
CLOCK FUNCTION" IN THE PREVIOUS SECTION) .
PREPARE FOR THE ALARM SETTINGS
A. "ALARM" TIME SETTING
1. PRESS THE ON/OFF KEY TO PUT THE SET INTO "STANDBY" MODE
2. PRESS AND HOLD AL-SET/AL-MODE KEY UNTIL THE DISPLAY SHOWS:
HOUR (FLASHING)
/ SEARCH- AND SKIP+
/ SEARCH- AND SKIP+
/ SEARCH- AND SKIP+
/SEARCH+ KEY TO SELECT 12-HOUR OR
/SEARCH+ KEY TO SET
/SEARCH+ KEY TO SET