MTD 760 Operator's Manual page 11

4. Select desired position for the seat, and secure with the
hex screw removed earlier (d in Figure 3-6).
a
b
Figure 3-5
5. To adjust the position of the seat, remove the hex screw on
the bottom of the seat. Slide the seat forward or backward
as desired. Reinstall the hex screw. See Figure 3-6.
d
Figure 3-6
Mulch Plug
Note: See the Attachments & Accessories section if you would
like information regarding adding a mulching system for your
model of tractor.
c
Tire Pressure
WARNING!
Maximum tire pressure under any
circumstances is 30 psi. Equal tire pressure should be
maintained at all times. Never exceed the maximum
inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
• Approximately 10 psi for the rear tires
• Approximately 14 psi for the front tires
IMPORTANT:
Refer to the tire sidewall for exact tire
manufacturer's recommended or maximum psi. Do not
overinflate. Uneven tire pressure could cause the cutting deck to
mow unevenly.
Fuel and Oil Fill-up
The fuel tank is located under the hood. Do not overfill.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel machine indoors or
while the engine is hot or running. Extinguish
cigarettes, cigars, pipes, and other sources of ignition.
IMPORTANT: Your tractor is shipped with motor oil in the
engine. However, you MUST check the oil level before
operating. Be careful not to overfill.
Service and check the engine oil as instructed in the separate
Engine Operator/Owner Manual packed with your tractor. Read
the instructions carefully.
IMPORTANT: It is important to NOT top off your fuel tank
when filling with fuel. Leave an expansion area available inside
the fuel tank to allow for the fuel to expand and for proper
ventilation. Otherwise the unit may not run properly. Fill the tank
in accordance with Figure 3-7.
Figure 3-7
S
ection
3 — A & S -U
SSembly et p
11 11