Samsung Level Link EO-RG920 User Manual page 578

Using the device
1
Level Link
Slide the Mode switch to the right to activate sending mode.
2
Level Link
Press and hold the Multifunction button for about 3 seconds to enter
Bluetooth pairing mode.
3
Level Link Place your Level Link within 30 cm of the paired audio device.
The Level Link and the audio device are now connected via Bluetooth. If the connection
fails, turn off the audio device and turn it on again. Then, repeat the steps above.
4
Plug the audio cable into the audio jack of the Level Link. Then, plug the other end of the
audio cable into the audio output jack of the multimedia player.
• T he method for connecting via Bluetooth may vary depending on the connected
devices. For more information, refer to the user manual of the connected device.
• W hen the Level Link is connected to a TV in sending mode, lipsync problems may
occur. It is recommended to connect the Level Link to a TV that supports the aptX
low-latency codec.
• W hen using the Level Link with a multimedia player, turn down the multimedia
player's volume before unplugging the audio cable to prevent sudden, loud
sounds.
• Y ou may experience drops in volume or noise depending on the connected
multimedia player's volume. To avoid this, appropriately adjust the multimedia
player's sound.
English(USA)
13
11