Installing A Hard Drive In The Removable Tray Module - Sans Digital MobileStor MS4UM User Manual

Installing a Hard Drive in the Removable Tray Module:

After verifying that the product body and related accessories are not missing or damaged,
please follow the steps below to install a hard drive in the removable tray module.
Step 1 Place the unit on a flat, stable surface. Make sure that the fan is not blocked and
there is appropriate space for heat dissipation. (Do not place the product near
water or any environment that may cause damage to the product).
Step 2 Press the key (included with this unit) into the lock hole located at the front of the
unit (Fig.1). Pull handle and remove tray (Fig.2).
Fig.1
Step 3 Unmount the plastic tray protector by removing the screws as illustrated (Fig.3).
Step 4 Fasten the Hard Drive with the screws (included with this unit) in the correspond
ing locations (Fig.4). Place the tray with the mounted HDD back into the case.
Fig.3
Step 5 Once the installation is completed, insert the tray back into the unit and firmly
push the handle to lock it in place (Fig.2).
Step 6 Connect all cables to the corresponding jacks. Then connect the power cord.
Step 7 Enclosure hardware installation is complete. You can power on the unit and
continue to Page 5 for the eSATA PCIe Card installation.
NOTE:
If you only need to install 1 to 3 hard disks, one hard disk must be inserted into HDD-1 location or the system will not work properly.
Fig.2
Fig.4
Page 4