Table Of Contents; Printed Wiring Board - Main Section - Sony sTR-V200 Service Manual

1. SERVICING NOTE
.......................................................... 3
2. GENERAL
.......................................................................... 4
3. DIAGRAMS
3-1. Circuit Boards Location ........................................................ 6
3-2. Schematic Diagram - Main (1/3) Section - .......................... 7
3-3. Schematic Diagram - Main (2/3) Section - .......................... 9
3-4. Schematic Diagram - Main (3/3) Section - ........................ 11
3-5. Schematic Diagram - Display Section - ............................ 13
3-6. Schematic Diagram - Panel Section - ................................ 15
3-7. Printed Wiring Board - Main Section - .............................. 17
3-8. Printed Wiring Board - Power Section - ............................ 21
3-9. Printed Wiring Board - Display Section - .......................... 25
3-10. Printed Wiring Board - 10 Key Section - ........................ 29
3-11. Printed Wiring Board - Panel Section - ........................... 31
3-12. IC Pin Functions ............................................................... 33
3-13. IC Block Diagrams ........................................................... 35
FACTORY SET
Mode which sets the preset settings of the unit to that at shipment.
Procedure:
While pressing the VIDEO button and TV/DBS button together, press the 1/u button to turn on the power.
"FACTORY" will be displayed and factory settings executed.
INITIALIZATION
Mode which erases all the preset settings of the unit.
Use this mode when returning the unit to the customer.
Procedure:
While pressing the VIDEO button, TV/DBS button, and TAPE/MD button together, press the 1/u button to turn on the power.
"INITIAL" will be displayed and initialization executed.
FLUORESCENT INDICATOR TUBE LIGHTING CHECK
Mode which lights up the whole fluorescent indicator tube or partially.
Procedure:
While pressing the TV/DBS button and TAPE/MD button together, press the 1/u button to turn on the power.
The fluorescent indicator tube will light up in about 0.5 seconds, and then start to light up partially. After partial lighting completes, the
BASS BOOST indicator will light up, "FINISH" will be displayed, indicating that fluorescent indicator tube lighting check has completed.
SWITCHING OF 9 kHz/10 kHz AM CHANNEL STEP
The AM channels of this unit can be switched between 9 kHz and 10 kHz.
Procedure:
Set FUNCTION to AM and turn off the power.
While pressing the TUNING + button, press the 1/u button to turn on the power.
"9 k STEP" or "10 k STEP" will be displayed, and the channel step will be switched.

TABLE OF CONTENTS

4. EXPLODED VIEWS
4-1. Case Section ........................................................................ 37
4-2. Chassis Section ................................................................... 38
5. ELECTRICAL PARTS LIST
SECTION 1
SERVICING NOTE
- 3 -
........................................ 39