ZB-Pro Professional 2.4GHz Network Management Tool FEDERAL COMMUNICATIONS COMMISSION NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 5 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 3
Microsoft Corporation in the United States and other countries. ZigBee is a registered trademark of the ZigBee Alliance. ZB-Pro, Integration Designer, and the RTI logo are registered trademarks of Remote Technologies Incorporated. Other brands and their products are trademarks or registered trademarks of their respective holders.
Page 4
ZB-Pro Professional 2.4GHz Network Management Tool...
It’s Under Control ® INTRODUCTION The ZB-Pro is a Professional Network Management Tool for use with RTI 2.GHz wireless ZigBee networks. Attached to a standard USB ® port of a PC, the ZB-Pro communicates with ZM-2 Transceiver Modules via 2.GHz RF. It can be used for several purposes which are...
Page 6
ZB-Pro Professional 2.4GHz Network Management Tool FEATURES The ZB-Pro incorporates many features that enable it to assist with the setup of the RTI 2.GHz ZigBee network. ® Updates the firmware in the ZM-24 Transceiver Module. Downloads network configuration data into a ZM-24.
Professional 2.4GHz Network Management Tool OPERATION Follow these steps to configure or update a ZM-24 Transceiver Module using the ZB-Pro: Insert the ZB-Pro into an available USB port of a PC running Windows XP or higher. ® Start the Integration Designer software program.
It’s Under Control ® SPECIFICATIONS Power Powered directly from USB port Requirements RF Frequency 2. GHz Range Wireless IEEE 802.5. (ZigBee Wireless Mesh ® Networking Networking) Operating +2F to +22F (+0C to +50C) Temperature Operating 5% to 95% non-condensing Humidity Dimensions .”...
Page 10
ZB-Pro Professional 2.4GHz Network Management Tool...
It’s Under Control ® TROUBLESHOOTING USB COMMUNICATION ISSUES If neither of the ZB-Pro Mode LEDs illuminate while performing the specific Integration Designer function follow these steps: ® Ensure that the ZB-Pro is seated properly into a powered USB port. If necessary, use 6” USB A-A extension cable that is provided.
Need help?
Do you have a question about the ZB-Pro and is the answer not in the manual?
Questions and answers