Mier DA-660 Installation Instructions Manual

Advertisement

8

WIRELESS DRIVE-ALERT OPTIONAL ANTENNA AND SENSORS

DA-660
DA-610TO
DA-611TO
The DA-660 Long Range Antenna is an option that can be used with all of Mier's Wireless Drive-Alert Systems to boost the recep-
tion-range from the sensor to the control panel up to 1/2- mile. This is a factory installed accessory and must be ordered at the time
of purchase by adding an "LR" to the end of the part number. Example: a DA-600 or DA-605P Drive-Alert with the with a DA-660
long range option would be a DA-600LR or DA-605PLR.
The DA-610TO Sensor/Transmitter is the standard sensor that comes with a DA-600 or DA-605P. The sensor and transmitter are
encased inside a durable NEMA 4 outdoor enclosure (see the DA-611TO if an external sensor is needed). The DA-610TO monitors
a 14 foot radius (28 foot sphere). Mier's sensors/transmitters require two AA batteries which will last more than a year under normal
residential usage. These sensors may be placed up to 1000 feet from the control panel, and up to 2500 feet when used with an "LR"
system which includes the DA-660 Long Range Reception Antenna. The sensors are tamper resistant due to the fact that if anyone
touches or moves one, the alert will be triggered.
The DA-611TO Sensor/Transmitter is an optional wireless sensor that can be used in place of, or in conjunction with, the
standard DA-610TO Sensor that comes with a DA-600 or DA-605P Drive-Alert. The DA-611TO is used in applications where it is
impossible to place a DA-610TO close to the driveway or area needing monitoring. The DA-611TO allows you to bury the sensor
right next to, or under, the driveway and then place the transmitter up to 50 feet away on a tree/pole (which also helps increase
transmission reception). If you want this option without the standard DA-610TO, order a Drive-Alert control panel only by adding
a "CP" to the end of the part number as well as the DA-611TO. Example: a DA-600 or DA-605P Drive-Alert with the DA-611TO
would be a DA-600CP or DA-605CP and a DA-611TO. Note: If you order a DA-605CP, make sure you also remember to order DA-
068 and/or DA-070 chimes too. An unlimited number of, or combination of, wireless sensors may be used to monitor several areas.
NOTE: If needed, Mier's wireless systems can be completely battery operated allowing them to be entirely mobile.
See the following pages for Installation Instructions of these options
Free Lifetime Technical Support
800-473-0213
~
info@mierproducts.com
~
www.mierproducts.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DA-660 and is the answer not in the manual?

Questions and answers

Summary of Contents for Mier DA-660

  • Page 1 1/2- mile. This is a factory installed accessory and must be ordered at the time of purchase by adding an “LR” to the end of the part number. Example: a DA-600 or DA-605P Drive-Alert with the with a DA-660 long range option would be a DA-600LR or DA-605PLR.
  • Page 2 DA-660 Reception Booster Antenna DA-660 • When a monitored location is more than 1000’ away, the DA-660 is the perfect accessory for the DA-600 or DA-605P wireless Drive-Alert Vehicle Detection Systems. • This antenna boosts the normal Drive-Alert range up to 1/2-mile •...
  • Page 3 1000 feet away. See the DA-611TO below if you are not able to place the sensor right next to the drive, and see the DA-660 to boost the reception range between the transmitter and control panel up to 1/2-mile.
  • Page 4 If a unique address code is needed (e.g. interference from a neighboring Mier wireless system) open the top cover revealing the transmitter circuit board. Look for the blue and white rocker switches labeled ADDRESS in the lower middle of the circuit board.
  • Page 5 WIRELESS DRIVE-ALERT SENSOR INSTALLATION page 3 of 4 DA-611TO (standard) Transmitter/Internal Sensor The Model DA-611TO Sensor/Transmitter contains the transmitting electronics, and sensor “wand” on a 50 foot direct burial cable. The Transmitter box must be placed at least 5 feet above ground on a post, tree, or hung from any convenient point. The front of the transmitter box should face the receiver for best range.
  • Page 6 WIRELESS DRIVE-ALERT SENSOR INSTALLATION page 4 of 4 With factory settings, install the Sensor/Transmitter at least 60 feet from streets or roads (see FIGURE 7). FIGURE 7 illustrates a typical installation for all receivers and sensor/transmitters. Underground OR Overhead Power or Telephone Lines 40 ft (min) Garage Driveway...

This manual is also suitable for:

Da-611toDa-610to

Table of Contents