Operating Instructions - Biasi RIVA OV M110.18SM/OV User Manual And Installation Instructions

Wall hung, fan flue, room sealed, high efficiency gas boiler

Hide thumbs

Table Of Contents

Table of Contents

1.1.2

Control of Substances Hazardous to

Health

Under Section 6 of the Health and Safety at

Work Act 1974, it is required to provide

information on substances hazardous to health.

The adhesives and sealants used in this

appliance are cured and give no known hazard in

this state.

Insulation Pads - These can cause irritation to

the skin, eyes and the respiratory tract. If you

have a history of skin complaints you may be

susceptible to irritation. High dust levels are

usual only if the material is broken. Normal

handling should not cause discomfort, but follow

normal good hygiene and wash your hands

before eating, drinking or going to the lavatory. If

you do suffer irritation to the eyes or severe

irritation to the skin seek medical attention.

1.1.3

Gas and Electricity Consumer Council

(Energywatch)

Energywatch is an independent organisation,

which protects the interests of gas users. If you

need advice concerning energy issues, they may

be contacted on their consumer help line

number: 08459 060708, or via their web site;

http://www.energywatch.org.uk

1.2

Safety

Read these user manual instructions and the

user label (fitted on the decorative front panel)

carefully before attempting to operate the

appliance. Comply with all applicable warnings.

Do not interfere with any sealed components

and use the appliance only in accordance with

these instructions.

1.2.1

Current Gas Safety (Installation and

Use) regulations or the rules in force

It is the law that all gas appliances

by a competent person in accordance with the

above regulations. Failure to install appliances

correctly could lead to prosecution. It is in your

own interest, and that of safety, to ensure that

the law is complied with. If the appliance is

damaged, turn off the appliance and consult a

CORGI registered installer.

If it is known or suspected that a fault exists on

the appliance it

MUST NOT be used until the

fault has been rectified by a competent person.

1.2.2

Supply: 230V ~ 50Hz fused at 3A.

This method of connection to the mains supply

must facilitate complete isolation of the

appliance. Either a 3A fused three pin plug and

un-switched shuttered socket outlet, or a 3A

fused double pole switch having a 3mm contact

separation in both poles, serving only the boiler

(and its external controls), may be used.

1.2.3

It is not neccesary to have a purpose

air vent in the room or internal space in which a

room-sealed appliance is installed.

Cupboard or compartment ventilation is not

necessary

providing that the minimum clearances are

maintained.

1.3

Please

with your appliance. This Logbook should be

completed by your installer to verify that the

correct

procedure was followed.

Failure to complete the Logbook may result in

difficulties should a problem arise with your

appliance during the guarantee period. This

Logbook forms part of the industry's Benchmark

code

commissioning and servicing of central heating

systems.

All CORGI Registered Installers carry a CORGI

ID card and have a registration number. Both

should be recorded in your Logbook. You can

check your installer is CORGI registered by

calling CORGI on 0870 401 2300.

are installed

1.4

Refer to Fig. 1

1.4.1

Switch on the electrical supply.

2 Turn the CH control knob to the midpoint

between minimum and maximum setting. The

display changes from

3 Ensure that all secondary controls, e.g.

programmer, room thermostat are calling for

heat.

Electrical Supply

This appliance must be earthed.

Clearances and Ventilation

for

room-sealed

Boiler Logbook

ensure that you have a Logbook supplied

installation

and

practice

for