Blomberg LWF29441W User Manual page 37

If the product has an emergency water draining hose, in order to drain the water:
a Pull the emergency draining hose out from its seat
b Place a large container at the end of the hose. Drain the water into the container by
pulling out the plug at the end of the hose. When the container is full, block the inlet
of the hose by replacing the plug. After the container is emptied, repeat the above
procedure to drain the water in the product completely.
c When draining of water is finished, close the end by the plug again and fix the hose in
its place.
d Turn and remove the pump filter.
4 Clean any residues inside the filter as well as fibres, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.
Washing Machine /User's Manual
37 / EN