Subscribe to Our Youtube Channel
Related Manuals for Bogen CSUB
Summary of Contents for Bogen CSUB
- Page 1 Ceiling Subwoofer Model CSUB Installation and Use Manual © 2008 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-2171-01B 0810...
-
Page 2: Product Description
NOTE The CSUB is not an outdoor speaker. Do not expose the CSUB to rain or moisture. The CSUB should only be installed by qualified personnel. Important Safety Instructions 1) Read these instructions. -
Page 3: Product Diagrams
Product Diagrams Front Drawing (grille removed) 1. Driver Assembly (internal) 2. Bass Tuning Vent 3. Grille Retention Groove 4. 24 Ceiling Tile Guide Arrows (×2) " 5. Power Tap Selection Switch 6. 14-1/2 Joist Space Guide " Arrows (×2) Front Drawing 7. -
Page 4: Speaker Placement
CSUB CSUB Note:The CSUB may be placed as close as 5" from a wall, provided care is taken to ensure that mounting clamps are properly extended (see Installation section). If mount- ing clamps cannot be properly extended, another location must be found. -
Page 5: Installation
2. A uniquely designed clamp screw assembly can be tightened from either the front or rear, allowing the CSUB to be mounted either by dropping the ceiling tile onto the rear of the CSUB or by dropping the CSUB into the front of the ceiling tile. This design can significantly accelerate the installation process. - Page 6 1. Remove the ceiling tile from the ceiling grid. Cut a 14-1/4" circular hole in the ceil- ing tile. Use the included template as a guide. Put the CSUB face down on a workbench or on the floor without grille installed. Place the ceiling tile over the CSUB, making 2×2 Ceiling Tile...
- Page 7 DRYWALL OR OTHER HARD SURFACES: Be sure you know the location of the ceiling joists before cutting the speaker open- ing. Cut a 14-1/4" circular hole where the CSUB will be installed. Use the includ- ed template as a guide.
-
Page 8: Speaker Wiring
Speaker Wiring All wiring should be done prior to installation and then plugged into the rear of the speaker. Wiring is terminated at a snap-lock input connector. There are two positive and two negative terminals to accommodate daisy-chaining of speakers in a sys- tem. - Page 9 Selecting Power Levels The front-mounted selector switch is used to set the appropriate power level or impedance for your system. Using your fingers or a flat-blade screwdriver, turn the knob until the arrow points to the power level you require. 70V Systems A power setting scale for 70V systems is labeled on the switch.
-
Page 10: Specifications
The CK10 is a 10-foot cable with one looped end and an adjustable cable clamp. It is suitable for use as a safety cable. On the CSUB Ceiling Subwoofer, the CK10 attaches to the safety tether point on the rear of the housing (see Product Diagrams). -
Page 11: Limited Warranty; Exclusion Of Certain Damages
Limited Warranty; Exclusion of Certain Damages The Bogen Ceiling Subwoofer, model CSUB, is warranted to be free from defects in material or workmanship for three (3) years from the date of sale to the original purchas- er. Any part of the product covered by this warranty that, with normal installation and use,... - Page 12 50 Spring Street, Ramsey, NJ 07446, U.S.A. Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com...
Need help?
Do you have a question about the CSUB and is the answer not in the manual?
Questions and answers