Voltage Selection - Madrigal Audio MARK LEVINSON 29 Operating Manual

Figure 1: Rear-panel label
PRECAUTION
2

Voltage selection

The Nº29 is factory-set (internally) for 100V, 120V, 200V, 220V, or 240V
AC mains operation. Check that the label on the rear panel of the
amplifier indicates the correct AC operating voltage for your location.
Voltage
indication
OPERATING VOLTAGE:
90 – 110 VAC~
105 – 125 VAC~
180 – 220 VAC~
210 – 240 VAC~
230 – 250 VAC~
~47 – 400 HZ
If the voltage indicated is incorrect, see your Mark Levinson dealer.
If you wish to change the AC operating voltage of your Nº29, see your
Mark Levinson dealer.
A Nº29 may be powered by a 15-ampere AC mains line. If other
devices are also powered from the same AC feed, their additional
power consumption must be considered.
The Nº29's fuses are located on the rear panel. Replace the fuses with
the same type only.
ALWAYS remove the AC cord before removing the fuses.
®
Nº 29
DUAL MONAURAL AMPLIFIER
WARNING:
HAZARDOUS VOLTAGES AVAILABLE INSIDE: DISCONNECT AC~ MAINS CABLE BEFORE REMOVING ANY
COVERS. HIGH ENERGY AVAILABLE AT LOAD TERMINALS: REFER TO OWNER'S MANUAL FOR PROPER
TERMINATION INSTRUCTIONS. DISCONNECT AMPLIFIER FROM AC~ MAINS BEFORE REPLACING FUSES.
MAINS FUSES: PLEASE CONSULT OWNER'S MANUAL.
D E S I G N E D A N D M A N U F A C T U R E D I N U . S . A . B Y
M A D R I G A L A U D I O L A B O R A T O R I E S , I N C .
+ – – +
OUTPUT
BALANCED BALANCED
INPUT INPUT
INPUT
INPUT INPUT
RIGHT CHANNEL LEFT CHANNEL
SERIAL NO.