Replacement Accessories - Black & Decker NST1118 Instruction Manual

cuttinG line / line feeDinG
Your trimmer uses .065 inch (1.65 mm) diameter, rounD nylon
line. During use, the tips of the nylon lines will become frayed and
worn and the special self feeding spool will automatically feed and
trim a fresh length of line. Cutting line will wear faster and require
more feeding if the cutting or edging is done along sidewalks
or other abrasive surfaces or heavier weeds are being cut. The
advanced automatic line feeding mechanism senses when more
cutting line is needed and feeds and trims the correct length of line
whenever it's required. Do not BumP unit on ground in attempt
to feed line or for any other purposes.

rePlacement acceSSorieS

caution:
Before you begin trimming, only use the appropriate
type of cutting line.
Use Black & Decker replacement spool Model No. AF-100.
Reload nylon line (either bulk or prewound replacement spool) as
shown in this manual.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
MONOFILAMENT LINE. Do not use serrated or heavier gauge
line, as they will overload the motor and cause overheating. This
line is available at your local dealer or authorized service center.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800-544-6986 or visit www.blackanddecker.com.
WarninG:
The use of any accessory not recommended by
Black & Decker for use with this tool could be hazardous.
rePlacinG the SPool
• Remove battery from tool.
• Depress the tabs (j) and
remove the spool cap (k) from
the spool housing (l) in the
trimmer head (figure 14).
• For best results, replace
spool with Black & Decker
model # AF-100.
• Grasp empty spool with one
hand and spool housing with
other hand and pull spool out.
• If lever (m) (figure 15) in
base of housing becomes
dislodged, replace in correct
position before inserting new
spool into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of the
cutting line and guide the line
into the eyelet (n) figure 16.
• Take the new spool and
push it onto the boss (o)
(figure 15) in the housing.
Rotate the spool slightly until it
is seated.
The line should protrude
approximately 5-3/8 inches (136mm) from the housing.
9
14
Replacement
spool
Model #
AF-100
j
15
m
n
k
j
l
o