Table of Contents
Advertisement
Quick Links
Fitting Instructions
RiteKey 30-01
Contents
Installing Keypad And Backplate ...............................................................
Wiring Details..................................................................................................
User Manual.................................................................................................
Adams Rite Europe Ltd, Moreton Industrial Estate, London Road, Swanley, Kent, UK, BR8 8TZ
Tel: +44 (0)1322 668024 Fax: +44 (0)1322 660996 E-mail: info@adamsrite.co.uk www.adamsrite.co.uk
(IP65 Rating Keypad Face Only)
®
ADAMS RITE
E U R O P E L I M I T E D
1-3
page
4
page
5-6
page
Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
Advertisement
Table of Contents
Summary of Contents for ADAMS RITE RiteKey 30-01
- Page 1 Wiring Details....................page User Manual....................page Adams Rite Europe Ltd, Moreton Industrial Estate, London Road, Swanley, Kent, UK, BR8 8TZ Tel: +44 (0)1322 668024 Fax: +44 (0)1322 660996 E-mail: info@adamsrite.co.uk www.adamsrite.co.uk Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
- Page 2 5. Ensure the MOV supplied is fitted to the lock either to its supply cables or on its supply connections on its terminal block. Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
- Page 3 Fig 5. Connecting the Cable Run and the block the correct way around with the cable entry pointing Block to the Keypad away from the PCB as shown in diagram 3. Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
- Page 4 Tighten the Allen screw and complete the remaining tasks as described. Fig.3 Inserting Keypad Cable into Back Plate Fig.4 Fitting Keypad to Back Plate Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
- Page 5 POWER AC/DC 11-16V Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
-
Page 6: Glossary Of Terms
• Enter the remaining digits of the new master code, the red LED should not be lit when each digit is pressed until the full code had been entered where it will light for approximately three seconds followed by the green LED flashing in standby. • Write down the master code. Fitting Instructions for Ritekey 30-01. Rev 3 June 2005. - Page 7 • Press any two keys from 01 to 99 for the new time delay in seconds (01 being 1 second and 99 being 99 seconds). • The green LED will then flash in standby. Fitting Instructions for Ritekey 30-01. Rev 3 June 2005.
Need help?
Do you have a question about the RiteKey 30-01 and is the answer not in the manual?
Questions and answers