Installation In A Sliding Sash Window - Danby DPA140HCB1WDD Owner's Use And Care Manual

Installation Instructions
INSTALLATION IN A
SLIDING SASH
WINDOW
1. Measure the adhesive foam seal to fi t the window stool. Cut the foam seal (ad-
hesive type) to the proper length and attach it to the window frame. See fi g. 13.
2. Adjust the length of the window slider kit according to the height of the window,
shorten the adjustable window kit if the height of the window slider is less than
72 cm (28.3 inches). Open the window sash and place the window slider kit on
the window stool. See fi g. 14.
3. Cut the foam seal (adhesive type) to the proper length and attach it to the top
of the window. Shown in fi g. 15.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap between the
top window sash and outer window sash. Shown in fi g. 16.
11
Window
Panel
Foam
Seal
Foam seal A
(adhesive type)
Fig.13
72 cm ~ 2,7 m]
28.3 in. ~ 81.5 in.
Fig.14
Fig.15
Fig.16