Fleetwood Tioga Montara 1995 Manual page 50

44
necessary. Be sure cable ends and terminals
are clean aM free of corrosion.
D
Check, tire pressures. Reinflate to specified
cold pressure.
D
Remove covering from inside windows.
D
Open vents and windows for ventilation.
D
Be sure engine instruments indicate proper
readings. Run engine up to operating tem-
perature. Shut engine down. Check all fluids.
Top up if necessary.
o
During engine run, check the operation of
headlights, tail-lights, turn signals, backup
lights, clearance lights, license plate light,
emergency flashers. Operate the vehicle air
conditioner. If air conditioner does not work, or
unusual sounds occur, have the system
checked by a qualified air conditioner
technician.
D
Drain, flush, and sanitize the fresh water sys-
tem as outlined in the "PLUMBING" chapter.
Inspect the drain hose for leaks. Replace if
necessary - repairs are usually not effective.
D
I nstall a new water purifier cartridge (if
equipped).
D
Operate all faucets and fixtures in the fresh
water system. Check for leaks at all joints and
fittings. Repair if necessary.
D
Check 12-volt circuit breakers and inspect
fuses.
D
Operate all 4 2-volt lights and accessories.
D
Install new batteries in battery-operated de-
vices. Check operator's manual fQr each de-
vice for additional requirements.
D
Test carbon monoxide, LP gas and smoke
detectors.
D
Check monitor panel operation.
D
Open and operate vents and vent fans, includ-
ing the range hood fan.
D
Inspect the 120-volt electrical system - power
cord, converter, all outlets, and any exposed
wiring. If defects are found, refer service to
your dealer or an authorized Fleetwood Ser-
vice Center.
D
Prepare the generator for operation following,
instructions in the generator operating man-
ual in your Owner's Information Package.
D
Start and run generator.
D
Operate 120-volt appliances and air condi-
tioners. Be sure to uncover air conditioner
shroud(s).
D
I nspectthe LP gas system and check for leaks
as described in the "LP GAS SYSTEM" chap-
ter. If the LP tank shows signs of rust or
corrosion, have It inspected by a qualified
LPG technician.
D
Operate each LP gas appliance. Observe all
burner/pilot flames for proper color and size.
In any case, have the LP gas regulator ad-
justed for proper pressure by a qualified
technician.
D
Inspect and clean the interior.
D
Check the sealant around all roof and body
seams and windows. Reseal if necessary.
See "Sealant Renewal" section.
D
Lubricate all exterior locks, hinges, and latches.
D
Re,install windshield wiper blades. Check
wiper/washer operation.
D
Wash and wax the exterior. Inspect the body
for scratches or other damage. Touch up or
repair as necessary. Flush the underside
thoroughly.
D
Run thorough operational checks of steering,
brakes, engine and transmission. Operate
vehicle slowly during these checks to allow
sufficient circulation of fluids and reseating of
components.
Your motor home should now be ready' for a new
traveling season. If you choose, your dealer can double
check your preparation and correct any defects or make
any necessary adjustments.