Needle Threader - Janome Memory Craft 350E Instruction Manual

Janome Embroidery 350E Instruction Manual
z
q
x
c
v
www.janomeflyer.com

Needle Threader

z
w
x
w
e
c
v
NOTES:
The needle threader works well with the threads #50-90
and needles #11-16, the blue tipped needle as well.
If the needle stops too low to use the needle threader
after the automatic thread cutting, raise the needle to
its highest position by turning the handwheel.
11
Lower the presser foot. Depress the needle
threader knob as far as it will go. The hook
comes out through the needle eye from behind.
q
Needle threader knob
w
Hook
Draw the thread down around the threader guide
and under the hook.
e
Threader guide
Release the threader knob slowly while holding
the thread end with your hand. A loop of the
thread is pulled up through the needle eye.
Remove the loop from the threader and pull out the
thread end from the needle eye.
350E Owners Manual/ User Guide