Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for ASUSTOR AS5002T
Summary of Contents for ASUSTOR AS5002T
-
Page 1: Quick Installation Guide
Quick Installation Guide For Network Attached Storage Ver.2.3.1111... -
Page 2: Table Of Contents
ASUSTOR NAS Quick Installation Guide Table of Contents Notices........................3 Safety Precautions ..................... 4 Package Contents .................... 5 Optional Accessories ..................7 Hardware Installation Guide ................8 Hard Disk Installation .................. 8 Connecting and Powering on the NAS ............10 Upgrading System Memory ................ -
Page 3: Notices
ASUSTOR NAS Quick Installation Guide Notices Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation. -
Page 4: Safety Precautions
ASUSTOR NAS Quick Installation Guide Safety Precautions The following safety precautions will increase the life of the NAS. Follow all precautions and instructions. Electrical safety • Unplug this product from the power source before cleaning. • Use only the bundled power adapter. Using other power adapters may damage your device. -
Page 5: Package Contents
ASUSTOR NAS Quick Installation Guide Applicable Models: AS5002T, AS5004T, AS5008T, AS5010T, AS5102T, AS5104T, AS5108T and AS5110T. Contents AS5002T AS5102T AS5004T AS5104T NAS device Power cord Adapter RJ45 network cable Screws for use with 3.5” HDD Screws for use with 2.5” HDD... - Page 6 ASUSTOR NAS Quick Installation Guide Contents AS5008T AS5108T AS5010T AS5110T NAS device Power cord RJ45 network cable Screws for use with 3.5” HDD Screws for use with 2.5” HDD Installation CD Quick Start Guide Page 6 of 23...
-
Page 7: Optional Accessories
ASUSTOR NAS Quick Installation Guide The items below may be purchased from local dealers and the ASUSTOR Accessories Store (http://shop.asustor.com). Other items such as HDMI cables (2M recommended), wireless RF keyboards, mice and remote controls along with Bluetooth keyboards and mice are purchased separately. -
Page 8: Hardware Installation Guide
ASUSTOR NAS Quick Installation Guide All data stored on the hard disk(s) will be erased and CANNOT be recovered. Please back up all important data before initializing the system. 3.1 Hard Disk Installation • Press the button on the lower portion of the hard disk tray to release the latch. - Page 9 ASUSTOR NAS Quick Installation Guide 2.5-inch hard disks and SSD hard disks: Place the hard disk into the area of the disk tray outlined in red (see picture below). Make sure that the mounting holes on the bottom of the hard disk and disk tray are lined up. Secure the drive with four screws.
-
Page 10: Connecting And Powering On The Nas
ASUSTOR NAS Quick Installation Guide 3.2 Connecting and Powering on the NAS • Connect the NAS to its power supply. • Connect the NAS to your router, switch or hub using an Ethernet cable. • Press and hold down the power button for 1 – 2 seconds until the blue power LED indicator is lit. -
Page 11: Upgrading System Memory
Be careful not to injure your hands or fingers with sharp edges of the memory module, inner components, or circuit boards of your NAS. • ASUSTOR does not guarantee that third party memory modules will work in your NAS. • Be sure to turn off your NAS and peripherals and disconnect all attachments and connection cables before adding or removing memory modules. -
Page 12: Parts And Tools Needed
ASUSTOR NAS Quick Installation Guide 3.3.2 • Phillips head screwdriver 3.3.3 • Shutdown the NAS by selecting [Shut down] from the ADM User Menu. • Disconnect all cables and devices connected to the NAS including the power cord. • Use a screwdriver to loosen the three screws found on the rear of the NAS as shown in the illustration. -
Page 13: Installing Memory
ASUSTOR NAS Quick Installation Guide • Grip the cover from both sides with two hands and then gently push it back to remove it from the chassis. 3.3.4 Note: When installing a single memory module, please ensure that it is the same size as the built- in memory module (1GB/2GB). - Page 14 ASUSTOR NAS Quick Installation Guide • Using two fingers, carefully push down and then back on the memory module until it clicks into place. You should be able to hear an audible “click”. To install the second memory module, continue with the steps outlined below.
-
Page 15: Replacing The Cover
ASUSTOR NAS Quick Installation Guide • When inserting the memory module into the empty slot, please make sure to align the notches on the module with the notches in the slot. Diagonally slide in the memory module (as shown in the illustration) making sure that the memory module’s connectors are fully inserted into the slot. -
Page 16: Software Installation Guide
There are 3 different installation methods that you can choose from. Please select the method most suitable for you. If you do not have a CD drive, you can go to the download section of the ASUSTOR website (http://www.asustor.com/service/downloads) to download the latest software. -
Page 17: Mac Users
Insert the installation CD into your computer’s CD drive and then select “Quick Install” from the autorun CD-menu. • The installation wizard will install ASUSTOR Control Center onto your computer. At this time you can also choose whether or not you want to install Download Assistant. After ASUSTOR Control Center has been installed, it will automatically begin to scan your network for ASUSTOR NAS devices. -
Page 18: Installation Using The Lcd Display
ASUSTOR NAS Quick Installation Guide 4.3 Installation Using the LCD Display • The LCD display will ask you whether or not you want initialize the NAS once it has detected that the NAS has not yet started to initialize. •... -
Page 19: Appendix
ASUSTOR NAS Quick Installation Guide 5.1 LED Indicators 1. Power LED Indicator 2. System Status LED Indicator 3. Network LED Indicator 4. USB LED Indicator 5. Hard Disk LED Indicator *For AS5008T, AS5108T, AS5010T and AS5110T models: When Ethernet cables are connected to [Ethernet Port 1] and [Ethernet Port 2] on the rear panel of the NAS, the first network LED indicator on the front of the NAS will become steadily lit. -
Page 20: Rear Panel
ASUSTOR NAS Quick Installation Guide 5.2 Rear Panel 1. S/PDIF Port 2. HDMI Port 3. eSATA Port 4. RJ45 & USB 2.0 Port 5. RJ45 & USB 3.0 Port 6. Reset Button 7. DC Input 8. K-lock 9. System Fan 5.3 Rating Label... -
Page 21: Troubleshooting
ASUSTOR NAS Quick Installation Guide 5.4 Troubleshooting Q: Why can’t I detect my ASUSTOR NAS using ASUSTOR Control Center? A: If you are having trouble detecting your NAS using ASUSTOR Control Center, please do the following: 1. Please check your network connection: a. - Page 22 ASUSTOR NAS Quick Installation Guide b. Click on [Change adapter settings] in the left hand panel. c. Right-click on [Local Area Connection] and select [Properties]. Page 22 of 23...
- Page 23 [IP address] to 169.254.1.1 and the [Subnet mask] to 255.255.0.0 and then click on [OK]. Open up ASUSTOR Control Center to scan for your NAS. 4. If the above mentioned procedures have not managed to solve your problem, please contact your local ASUSTOR dealer or ASUSTOR Customer Service (http://support.asustor.com).You...
Need help?
Do you have a question about the AS5002T and is the answer not in the manual?
Questions and answers