Tablet Detergents - Beko DIN 5833 Extra Instruction Manual

3. Close the detergent dispenser lid
by pressing on it lightly. A "click"
will be heard when the lid is closed.
C
In programmes with prewash and
at high temperature, in which you
use tablet detergents, make sure
that the detergent dispenser lid is
closed firmly.
A
C
Use powder detergent in short
programmes without prewash
since the solubility of the tablet
detergent changes depending on
the temperature and time.
A
Excessive usage of powder
detergents will cause the detergent
not dissolve completely and will
also cause scratches on the
glassware.

Tablet detergents

Table detergents exhibit water
softening and / or rinse aid effect in
addition to detergent effect. Some
types of these detergents also contain
25cm³
special-purpose washing chemicals
15cm³
1
such as glass and stainless steel
protectors.
2222
C
Tablet detergents give satisfying
results only under certain usage
conditions. The best washing
performance in dishwashers is
obtained by using detergent,
2
5cm³
rinse aid and water softening salt
individually.
C
Information about suitable places
(detergent dispenser, basket etc.)
in the dishwasher to place the
tablet can be found amongst the
usage instructions on the packages
of the tablet detergents.
Tablet detergent types commonly found
in the market:
2in1: Contains detergent, rinse aid or
water softening salt
3in1: Contains detergent, rinse aid and
water softening salt
4in1: Contains glass protectors in
addition to detergent, rinse aid and
water softening salt
5in1: Contains glass and stainless
steel protectors in addition to
detergent, rinse aid and water
softening salt
C
Observe the instructions of
the detergent manufacturer on
the package when using tablet
detergents.
When you switch to powder
detergent from tablet detergent:
1. Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the
highest level and perform an empty
run.
3. After the empty washing cycle,
review the user manual and
readjust the water hardness level
so as to suit the water supply.
4. Make the appropriate rinse aid
settings.
C
Depending on the model, salt
indicator and/or rinse aid indicator
must be enabled again if they were
disabled before.
14 EN