Electrical Safety; Using An Extension Cable; Assembly And Adjustments - DeWalt DCS391 Original Instructions Manual

1 M4 X 18 Cap screw
2 Li-Ion battery packs (L2, M2 models)
1 Kitbox
1 Charger
1 Instruction manual
1 Exploded drawing
NOTE: Battery packs, chargers and kitboxes are not
included with N-models.
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 4, 6)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Trigger switch lock-off button
b. Trigger switch
c. Battery pack
d. Depth adjustment lever
e. Shoe
f. Lower blade guard retracting lever
g. Lower blade guard
h. Blade clamping screw
i. Kerf indicator
j. Bevel adjustment knob
k. Blade lock button
l. Auxiliary handle
m. Battery release button
n. Hex key
o. Rip guide knob
p. Rip guide
INTENDED USE
Your DCS391 cordless circular saw has been
designed for professional sawing applications.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty circular saws are professional
power tools. DO NOT let children come into
contact with the tool. Supervision is required when
inexperienced operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.

Electrical Safety

The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
Your D WALT charger is double insulated
e
in accordance with EN 60335; therefore
no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
e

Using an Extension Cable

An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see Technical Data). The minimum conductor size
is 1 mm ; the maximum length is 30 m.
2
When using a cable reel, always unwind the cable
completely.

ASSEMBLY AND ADJUSTMENTS

WARNING: Prior to assembly and
adjustment, always remove the battery
pack. Always switch off the tool before
inserting or removing the battery pack.
WARNING: Use only D
packs and chargers.
Inserting and Removing the
Battery Pack from the Tool (fig. 2)
NOTE: For best results, make sure your battery
pack is fully charged. The light will shut off without
warning when the battery is fully discharged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack (c) with the rails inside the
tool's handle (fig. 2).
2. Slide it into the handle until the battery pack is
firmly seated in the tool and ensure that it does
not disengage.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the battery release button (m) and firmly
pull the battery pack out of the tool handle.
2. Insert battery pack into the charger as
described in the charger section of this manual.
E NGLISH
WALT battery
e
11