Table of Contents
Advertisement
KX-FM131RS
2.2.
Analog Board Section
Change from original pages 79~80 (2.3.3.5. Analog Board Section)
This chapter provides the testing procedures required for the analog parts. A signal route to be tested is determined depending
upon purposes. For example, the handset TX route begins at the handset microphone and the signal is output to the telephone line.
The signal mainly flowing on this route is analog. You can trace the signal with an oscilloscope. The signal flow on each route is
shown in the Check Sheet here. If you find a specific problem in the unit, for example if you cannot communicate with the H/S, trace
that signal route locally with the following Check Sheet and locate the faulty point.
Note:
{ }: Inside the digital board
6
Advertisement
Table of Contents
