Samsung RF26D-Series User Manual page 9

DISASSEMblEThEREFRIGERATORDOORS
1. With the door opened, remove the Top Table cap (
head screwdriver, and close the door. Remove the 3 screws
holding down the Top Table and remove the Top Table(
2. Disconnect the electrical connector
( ) above the upper right door hinge and the 3

electrical connectors ( ) above the

upper left door hinge.
Disconnect the water tube (
pulling the tube fitting (

shown in the picture.
3. Remove the 3 hex head bolts(
to the upper left and right door hinges with a
Wrench(10mm).
With a Philips head screwdriver, remove the
ground screw( ) found attached to the upper

left and right door hinges. Remove the upper left
and right door hinges( ).
9
4. Lift the door straight up to remove.
5. With a Philips head screwdriver, remove the 2
screws ( ) attached to the lower left and right
0
door hinges.
With a Allen wrench(5mm), remove the 2 hex
head bolts ( ) attached to the lower left and right

door hinges.
Remove the lower left and right door hinges(
• Be careful not to missplace the hinge cap because it can be easily taken off.

) by

) apart as
Red Clip
(1/4")
) found attached

Dispenser
Door Tube
9
).

) with a Flat
).





Cabinet
Tube



0



Cabinet
Tube
Dispenser
Door Tube
Red Clip
(1/4")
SettingUp _9