2. INSTALLATION INSTRUCTIONS
2-1. HOW TO ADJUST LEVEL
Installation area
1
Install the washer on a firm, flat
•
surface.
If the washer is installed on an
•
unsuitable floor, it could make
considerable noise and vibrate.
Set Leveling feet
2
Adjust the leveling feet, Turn clockwise
•
to raise the washer or
CAUTION
counterclockwise to lower it.
Raise
No shims. It would be dangerous. If the
floor is that far from being level, it is a floor
problem and not a washer problem.
CAUTION
CAUTION
• The ventilating openings in the base area must not be obstructed by carpeting.
• Install the washing machine on a level and firm surface. There should be no more than 1° of variation.
• Wooden floors may need reinforcing to prevent the normal vibration which occurs
with an unbalanced load.
• Do not install the washer on an inclined floor.
Improper installation of the washer may cause noise and malfunctioning.
3
4
Lower
4
Raise
Checking level
Open the lid, check if the washer is
•
correctly leveled by looking down
from the top. If the tub is not
centered in the opening, then the
washer is not level.
Raise
Raise
Checking slope
If installation surface is tilted, the
•
washer will vibrate. Do not install
on a sloping floor.
Lower
Lower
Lower