REMOTE CONTROLLER CUSTOM CODE SETTING
Use the following steps to select the custom code of the remote controller. (Note that
the air conditioner cannot receive a signal if the air conditioner has not been set for
the matching custom code.)
(1) Press the START/STOP ( / ) button until only the clock is displayed on the
remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current custom code
(initially set to ).
(3) Press the SET TEMP. (
→
→
→ .
Match the code on the display to the air conditioner custom code.
(4) Press the MODE button again to return to the clock display. The custom code will
be changed.
If no buttons are pressed within 30 seconds after the custom code is displayed, the system returns to the original
•
clock display. In this case, start again from step 1.
The air conditioner custom code is set to A prior to shipment.
•
REMOTE CONTROLLER TEMPERATURE UNIT
To change the temperature unit:
(1) Press the TEMP. (Up) button ( ) for at least 5 seconds to display the current temperature unit. (Factory setting: °F)
(2) Press the TEMP. buttons (
(3) With either of pressing the START/STOP button or no additional button operation for 30 seconds in step 2., the
temperature unit currently selected will be set.
/
) buttons to change the custom code between
/
) to switch the temperature unit. (°F ↔ °C)
- (01 - 31) -