Samsung WW90H7600E User Manual page 16

7. Connect the other end of the water supply hose to the inlet valve on
the back of the washing machine. Turn the hose clockwise to tighten.
8. Open the water tap and check if there are any leaks around the
connection areas. If there are water leaks, repeat the steps above.
• If using a screw type of water tap, connect the water hose to the
water tap as shown.
• Use a popular type of water taps. If the current tap is squareshaped or
too big, remove the spacer ring before inserting the adaptor into the
water tap.
WARNING
Stop using the washing machine if there is a water leak, and contact a local Samsung service centre.
Otherwise, this may cause electric shock.
CAUTION
Do not stretch the water supply hose by force. If the hose is too short, replace the hose with a longer,
high-pressure hose.
• After connecting the water supply hose to the adaptor, check if it is connected properly by pulling
the water supply hose downwards.
• Use a popular type of water taps. If the tap is square-shaped or too big, remove the spacer ring
before inserting the tap into the adaptor.
For models having an additional hot water inlet:
1. Connect the red end of the hot water supply hose to the hot water
inlet on the back of the machine.
2. Connect the other end of the hot water supply hose to the hot water
tap.
WW90H7410EW-03403Q-07_EN.indd 16
English - 16
2016/1/30 14:29:10