GETTING STARTED GUIDE
Basic MIDI Hookup
To use the Artis as a MIDI controller for another sound module, use a MIDI cable to connect
the MIDI port marked "Out" to the MIDI input port of the module that you want to control.
To control the Artis using another MIDI controller, use a MIDI cable to connect the MIDI
port marked "In" to the MIDI output port of the controller that you will be using.
For other MIDI connection scenarios, please refer to the Artis Musicians Guide.
The Pedal Jacks
Use the three pedal jacks to connect controller pedals to the Artis.
Switch Pedals
Continuous Control
(CC) Pedals
In Program Mode, the default function of each pedal can be changed for all Programs by
setting a pedal override on the Master page in Global Mode. Pedals are all independently
assignable within each Zone of every Multi.
Here are the default control settings for the three pedals used by Artis:
1/4 inch tip-sleeve (mono) plug or, 1/4 inch tip-ring-
sleeve plug configured as dual switches (TS and RS) or
2 terminal continuous pedal (half-damper).
10 kΩ linear-taper potentiometer, 1/4 inch tip-ring-sleeve
(stereo) plug with the wiper connected to the tip.
The Rear Panel
Basic MIDI Hookup
GS-5