Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Mylek kpt-2000b
- Page 1 USER INSTRUCTIONS Product Code: KPT-2000B 5201L PTC Over Door Heater and Fan...
- Page 2 IMPORTANT Installer and Users please note: These instructions should be read carefully before installation and/or use and left with the user of the product for future reference. BEFORE USE You must inspect the appliance including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.
-
Page 3: Operating Instructions
The two-stage temperature is suitable for different environments. Technical Data Type Specification Voltage Frequency Power KPT-2000B 5201L remote control 230V 50 Hz 1000W/2000W Installation The heater is intended to be mounted at least 1.8m height and over a door or entrance. - Page 4 PAT TESTING When used in a workplace, this product must be safety-tested yearly by a qualified electrician (PAT Tested) in order to comply with the Electricity at Work Regulations. We recommend that it is PAT tested regularly when used in a domestic environment. GENERAL SAFETY REQUIREMENTS Domestic wiring must be tested periodically by a qualified electrician at least once every 10 years or at every change of occupancy.
- Page 5 During use press ‘+’& ‘-‘ to control the temperature. When the room temperature rises to the required/set temperature the heater will turn off. When the room temperature drops to below 3 ℃ of the set temperature, the heater starts to operate again. Regulate temperature by ‘+’...
Need help?
Do you have a question about the kpt-2000b and is the answer not in the manual?
Questions and answers
Hi. Point five says, Do not install the heater directly under the socket outlet. Does this mean, the socket outlet should not be below the air flow?, which would means it shouldnt be fitted above the socket, therefore the socket should not be below it. I ask because it’s a debate on FB
Yes, the installation guideline specifies that the heater should not be installed directly under the socket outlet.
This answer is automatically generated