Before Washing For The First Time; Transportation - Bosch WAE24167GB Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. In
order to remove any water which may
be left over from the test, run the first
washing cycle without any laundry.
Notes
The washing machine must be
correctly installed and connected
(from ~ Page 25).
Never use a damaged machine.
Inform the after-sales service.
~ Page 24
Check the washing machine.
1.
Connect the mains plug.
2.
Turn on the tap.
3.
Switch on the appliance.
4.
Close the washing machine door (do
5.
not load any laundry).
Select the Cottons 90 °C
6.
programme.
Open the detergent drawer.
7.
Pour approximately 1 litre of water
8.
into compartment II.
Add standard detergent to
9.
compartment II according to
manufacturer's instructions for light
soiling.
To prevent foaming, only use
Note:
half the recommended amount of
detergent. Do not use detergents
designed for woollens or delicates.
Close the detergent drawer.
10.
Press the Start button.
11.
Switch off the appliance when the
12.
programme has finished.
Your washing machine is now ready to
use.
Positioning and connecting

Transportation

E.g. when moving house
Preparatory work:
Turn off the tap.
1.
Reduce the water pressure in the
2.
supply hose.
Cleaning and maintenance – the
water inlet filter ~ Page 21
Drain the remaining detergent
3.
solution.
Cleaning and maintenance –
detergent solution pump blocked
~ Page 20
Disconnect the washing machine
4.
from the mains.
Remove the hoses.
5.
Fitting the transportation safety
devices:
Remove the covers and keep in a
1.
safe place.
If required, use a screwdriver.
Insert all four sleeves.
2.
Clip the mains cable securely into
the holders. Insert and tighten the
bolts.
Before initial use:
Notes
The transportation safety devices
must be removed.
To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and select
and start the Empty programme
en
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents