Bissell PROHEAT 2X LIFT-OFF 1560 Series User Manual page 13

Maintenance:
1
Pod
Release
Pedal
To replace Small
Belt, flip the Base
Unit to the side
with the Pod
Release Pedal on
the bottom
Maintenance:
1
To replace Large Belt or Rollers, first remove small belt
(see first 3 steps above). Remove the only screw holding
Pivot Arm, gently pull off arm with attached Rods
2
Replace Large Belt or Brush Rollers,
as required, carefully reassembling
the Rollers and Pivot Arm with
attached rods and secure the Pivot
Arm with the screw
Replacing Small Belt
Screw 1
End
Cap
Screw 2
Screw 3
Using Phillips
screwdriver,
remove three
screws from
the End Cap
and set to side
Replacing Large Belts and Rollers
2
Pivot Arm
Small
Belt
Roller
Remove the end cap
first. Then, remove
the only screw
holding Pivot Arm,
gently pull off arm to
expose Roller ends
Washer
IMPORTANT: Do not lose
the small washers held by
a magnet at both ends of
the Brushroll.
3
Pod Release Pedal
To replace the
Small Belt, flip
Base Unit with the
Pod Release Pedal
on the bottom
3
Small
Belt
Replace the Small
Belt before
reversing steps to
reassemble Pivot
Arm and End Cap
4
Small
Belt
Remove screw to
Pivot Arm, replace
the Small Belt
and reassemble
the End Caps
www.BISSELL.com
13