Vehicle Jack - Mercedes-Benz 300 SL Operator's Manual

Vehicle Jack

1. Jack arm
2. Jack base
3. Tool kit
See illustration for proper storage of
jack.
Before storing the jack, the jack arm
(1) must be lowered almost to the base
(2) of the jack.
Note:
First remove the vehicle jack, then the
spare wheel; reinstall in reverse order.
Warning!
The jack is designed exclusively for
jacking up the vehicle at the jack
tubes built into either side of the
vehicle. Use the jack only to lift the
vehicle during a wheel change. Never
get beneath the vehicle while it is
supported by the jack. Keep hands
and feet away from the area under
the lifted vehicle. Always firmly set
parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake
while the vehicle is raised. Be certain
that the jack is always vertical when
in use, especially on hills. Lower the
vehicle onto sufficient capacity
jackstands before working under the
vehicle.
Vehicle Tools
The vehicle tools (3) are located below
the jack.
Wheels
Replace rims or tires with the same
designation, manufacturer and type as
shown on the original part. See your
authorized MERCEDES-BENZ dealer
for further information.
Warning!
Do not mix different tire con-
struction types (i.e. radial, bias, and
bias-belted) on your car because
handling may be adversely affected
and may result in loss of control.
See your authorized MERCEDES-
BENZ dealer for information on tested
and recommended rims and tires for
summer and winter operation. They
can also offer advice concerning tire
service and purchase.
103